View the QoS Ingress Port-Rate Limit Information

Use this procedure to view the QoS ingress port-rate limit information. The system displays the port, rate limit in Kbps, and rate limit status.

Note

This procedure applies to VSP 4900 Series only.

Procedure

Enter Privileged EXEC mode:

enable
View the ingress port-rate limit information:

show qos rate—limiting interface gigabitEthernet [{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}]

Example

Switch:1# show qos rate-limiting interface gigabitEthernet 1/1

================================================================================
                           Port Ingress Rate-Limiting
================================================================================
--------------------------------------------------------------------------------
PORT    RATE(kbps)         ENABLED/DISABLED
--------------------------------------------------------------------------------
1/1     0                  DISABLED

Variable definitions

Use the data in the following table to use the show qos rate—limiting interface gigabitEthernet command.


Variable	Value
port `{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}`	Identifies the slot and port in one of the following formats: a single slot and port (slot/port) a range of slots and ports (slot/port-slot/port) a series of slots and ports (slot/port,slot/port,slot/port) all ports on the same slot (slot/all) all ports on the switch (all) If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.